Shown here is the loading of a compost turning machine that weighs 12,000 lbs. These ramps were custom designed to allow loading from the side of the trailer

This adjoining section modular system is designed to carry 7000 maximum axle loads. This system is 10 feet wide by 30 feet long and weighs in in at 1800 lbs all inclusive of parts including stands, ramps, stringers and pins.

• Easily assembled or disassembled by two men in as little as twenty minutes. Each 30 inch x 120 inch ramp section weighs just 110 lbs.
• Portable. May be setup in any location
• Self cleaning high traction cleats provide superior traction
• Transition plates bridge gap between dock and ramp system
• Continuous surface allows for wide and narrow vehicle access
• Adjustable stand height allow for low clearance vehicle access as well as varrying climb angle

Mercedes under coats it's cars with a special wax that seeps into all the small crevices providing protection from road salts and other contaminates. Workers require access to the under side of each car to apply this coating. Mercedes goal is to complete each car in 2 ½ minutes.

Lifting, then lowering the car from the floor to a comfortable work height, then to the floor took 40 seconds. The solution, use Heavy Duty Ramps, built to withstand a car every 2 ½ minutes, to drive onto their lift raised half the height required. This cut their lift time in half to 20 seconds.